TRA-Mage, Inc. - Roof Ventilation System

Aluminum Roll-Product Information:

Metal

highly durable and weather resistant
maximum formability and long term functionality
fully recyclable

Net free airflow

9 sq. per running foot (9" width)
10 sq. per running foot (11" width)

Continuous Corrugation

stretching factor of 30%
conforms to roof surface
suitable for hip application
easy installation
no tools necessary

High Quality Color Coating

durable UV resistant
available in many colors (RAL)

ICC#: ESR-1787

passed Dade County wind driven rain test (PA 100(A)-95)
passed ICC dust test (AC132)

Perforated

continuous air exhaust
reliable weather block
exceeds DIN 4108 /3

Butyl Adhesive Strips

additional security against driving rain and snow

Perforated

measurable ventilation area according to DIN 4108/3 ICC-ES AC 132

Technical Information

body: aluminum corrugated and colored
width: 9 in. / 11 in. / 15 in.
length: 25 ft. per roll
standard colors: red, brown, black

Application Steps:
General Information- FlexVent™ should overlap 2 inches. Roof tile must be clean and dry. Air temperature should be at least 40° F.

		Step 1 Center FlexVent™ on top of roof nailing board. Staple or nail FlexVent™ every 12 inches down hip or ridge nailing board.
		Step 2 Form FlexVent™ to tile roof surface. Take care that ventilation area does not press too tight to surface nailing board preventing proper airflow. Install FlexVent™ from top of hip to eave.
		Step 3 Remove protective strip from adhesive tape.
		Step 4 Press FlexVent™ in pans of each tile. FlexVent™ can elongate 30% from barrel to pan. Take care that the edge area of FlexVent™ is thoroughly pressed to tile for optimal adhesion.
		Step 5 Cut off excess amount of FlexVent™ at end of hip or ridge with knife or sheet metal shears. The excess material can be used on the next project.

Call for more details!
(800) 606-8980